Your SEAT has a remap, the map asks for more torque, and the car still feels like it hits a wall. Before you blame the turbo or the tune, run through this checklist. It takes one datalog and a bit of patience.
Step 1: Log the right channels
You need two lines on the same graph: the torque the ECU is asked for, and the torque it actually delivers. Names differ between ECU families, so check your tool's channel list for something like requested (wish) torque and actual (indicated) torque. Add engine speed, boost pressure and gear.
Step 2: Read the gap
| What you see | What it usually means |
|---|---|
| Requested and delivered torque match | No limiter involved; look at boost, fuelling or ignition |
| Requested rises, delivered goes flat at one value | A torque limit is capping the output |
| Flat only in some gears | A gear-dependent limit |
| Flat only in an RPM band | A speed-dependent limit |
| Diesel: delivered torque drops, air is low | The smoke limiter, not the torque limiter |
Step 3: Rule out the lookalikes
A flat torque curve is not always the limiter. Check these first:
- Boost control. If actual boost is below target, the limiter is not your problem.
- Ignition timing pull on petrol (MED17, MG1), often from knock or high intake temperature.
- Smoke limiter on diesel (EDC17, MD1), which limits fuel against available air.
- Heat. Many ECUs reduce torque when temperatures rise.
Step 4: Know what removal really involves
The limiter is the last cap in the torque chain. The ECU gathers requests (pedal, gearbox, ESP, cruise), picks a winner and cuts it to the limit before setting throttle, boost, ignition and fuel. Taking it out means the driver's wish, boost and air-charge targets must be able to support the new torque level. Otherwise the ceiling just moves.
Step 5: Check the hardware
| Part | Why it matters |
|---|---|
| Clutch | First to slip when torque goes up |
| Gearbox (manual or DSG) | Has its own torque rating |
| Driveshafts and mounts | See every extra Nm |
| Engine | Boost and load rise with torque |
Step 6: Compare before and after
Repeat the same logged pull after any change, in the same gear and under similar conditions. If requested and delivered torque now follow each other and nothing else misbehaves, the job is done.
Quick troubleshooting notes
- Flat in one gear only? Look for a gear-dependent limit; the other gears may already be fine.
- Curve drops late in the rev range? That can be a speed-dependent cap, or simply the turbo running out of breath.
- Torque looks right but the car feels slow? Check the gearbox: a transmission that asks the engine for torque cuts at shifts can hide the gain.
- Changed one thing and another limit appeared? That is normal. The chain has several caps, so work through them one by one and log after each change.
Which SEAT ECUs are covered?
Schiller Tuning's Torque Limiter OFF service lists 22 SEAT variants: Bosch MED17 and MG1 on petrol, Bosch EDC17 and MD1 on diesel. Exact lists and the upload form are on the SEAT tuning file page. The service is from $100 per file, a tested file comes back in 10–20 minutes, and engineer review plus a 30-day warranty are included.
Want to learn the logging side?
Datalogging is the skill that makes this checklist work. See the ECU Datalogging Training Course, and the background reading in Torque-Based ECU Strategy.
More torque means more load on the engine, clutch, gearbox and drivetrain. Modifications can affect road legality, type approval and insurance, so check local rules before use.