A customer in Dongguan sent us an aluminum housing last spring — the kind with a big open cavity and walls milled down to about two millimetres. The drawing looked straightforward. We cut it, measured it on the machine, everything inside tolerance, and packed it. Two days later he called: the wall had bowed in. Nothing dramatic, maybe four or five hundredths, but enough that his cover no longer sat flat.

That batch was on us. It taught me that on a thin-wall cavity, the number you measure while the part is clamped is not the number you ship.

The vise was the problem, not the program

We had held it too hard at the two corners. When you squeeze a thin wall and then let go, it springs back to a shape you did not program. I have seen shops chase this with the cutter, taking another pass to "fix" a dimension that was never wrong — the wall was just still bent when they measured it. We reworked ours with softer jaws and a couple of extra contact points, and we measure again after it comes out of the vise, not before.

Whether that is enough depends on the alloy and how much material you took off. 6061 behaves itself; some of the higher-silicon stuff moves in ways I still would not call predictable. Every shop has a story about a part that looked fine on the machine and came back angry, and I am sure ours is not the only one.

Heat is the other half of it

Aluminium arrives at whatever temperature the truck was. Rough a cavity in the morning, finish it after lunch once the part has soaked up the cutting heat, and you will measure two different sizes. On these housings we either let the part rest between rough and finish, or do both in one setup and let the coolant work. Taking the part out to measure and putting it back is where a lot of the drift creeps in.

Summer in Shajing is not a controlled lab. The shop gets warm, the aluminium gets warm, and you learn to read a measurement with the temperature in mind instead of trusting the digit on the screen.

What we tell buyers now

If your housing has a thin wall with a flatness or position callout, ask the shop how it holds the part and when it measures — before or after unclamping. That question tells you more than a capability sheet. We will give you a straight answer on ours, including the features we would argue about rather than promise.

CHX Precision Metal runs CNC milling and turning in Shenzhen, including aluminum housings and cavity parts, with tolerances down to +/-0.005 mm where the drawing calls for it. More on our aluminum housing CNC machining.

CHX Precision Metal — precision CNC machining in Shajing, Bao'an, Shenzhen. MOQ 1 piece, prototypes 3-7 working days, batch production 7-15 days, EXW Shenzhen.